design in compliance with all rules?

[FRC1625]

My teams robot bumper perimeter polygon, other than some proportional dimension differences, was inspired by and is virtually identical to "Overhead View Figure 8-2" of page 10 of 32 of the Robot section of the Competition Manual. Our robots bumper configuration, other than the above mentioned dimension differences, the left and right sides of the robot covered completely by bumpers (without the gaps shown in the drawing), and our bumper meeting corners all to be of the three conditions indicated as acceptable in the overhead view, will be virtually identical to "Overhead View Figure 8-2". It is our intent to meet all of the other requirements of <R08> as included in the competition manual and team updates to date. Assuming we are successful in meeting these requirements will our robot be legal with respect to these items? my team has invested a lot of time, financial resources and energy in an almost complete chassis and robot design as described above and your timely response will be much appreciated.

Thank you

[GDC]

Lacking the ability to directly examine a particular robot, we cannot comment on the specific level of compliance with all the rules that may be represented by an individual design. That is the responsibility of the team of inspectors at each competition event.