Bumper Construction III

[2010FRC1922]

In section 07 Robot the rule specifies a 3/4" plywood backing. What we would like to do is to use one piece of 1/2" and a piece of 1/4 in plywood to make the proper thickness. As in upholstering furniture we would sandwich fabric ends between the plywood pieces. All surfaces would be covered and the total thickness of the hard material would be 3/4". This would allow us to eliminate the suggested metal banding which has always been a problem with the bumper with the extended noodles. Maybe a third time is a charm????

Thanks
__________________
Will Renauld
Team #1922
OzRam
Contoocook, NH.
Edit/Delete Message

[GDC]

Rule <R07-D> requires a single piece of 3/4 inch plywood be used. The configuration you described would violate this rule.