Non-Rectangular Robot and Bumpers

[FRC467]

Our robot design is narrower on one end than the other. There is about a 20 degree angle on each side. Therefore we will need two sections of plywood for each side section. Assuming there is one pool noodle that extends the whole length of the side, which bends around the small angle, is it permissible to attach the two sections of plywood with hinges or other fastener, so as to not end up with many smaller sections that would need to be removed individually?

[GDC]

Yes, as long as the section are still attached to the robot via the required bolt-and-fastener system (defined in Rule <R08>).